CanServo/ID2/en
Jump to navigation
Jump to search
ID2 is a 4 byte value: registers 0x3E, 0x3C are called together.
- 0x3C - High 2 byte
- 0x3E - Low 2 byte
According to the CanServo/MODE/CAN/en setting, specify the CAN ID or Node ID ( CanServo/ID/Node/en ) of the servo.
- Refer to CanServo/Packet Accept Rule/en for the packet reception procedure in CanServo/MODE/CAN/en = CAN 2.0A, 2.0B.
Communication settings including this setting are applied at the time of servo reset.
When changing, SAVE and Servo Reset are required.