Difference between revisions of "CanServo/Protocol/V1.7"

From HITEC_HELP
Jump to navigation Jump to search
Line 3: Line 3:
* Process
* Process
** Cali Unlock: Write Reg 0x70: 40092, 40017, 40069
** Cali Unlock: Write Reg 0x70: 40092, 40017, 40069
** Cali Clear Data
*** Write 0x70, 3843
*** delay 100 msec
*** delay 100 msec
** Cali Start: Write 0x70, 3848
** Cali Start: Write 0x70, 3848
Line 11: Line 9:
*** Write 0x70, 3849
*** Write 0x70, 3849
*** delay 1 sec
*** delay 1 sec
* Erase Data
** Unlock
** Cali Clear of Cali Data
*** Write 0x70, 3843
** Reset


* Message
* Message

Revision as of 01:26, 25 September 2025

Pot Calibration

  • Process
    • Cali Unlock: Write Reg 0x70: 40092, 40017, 40069
      • delay 100 msec
    • Cali Start: Write 0x70, 3848
    • Cali Set Position: ZPST message
    • Cali End
      • Write 0x70, 3849
      • delay 1 sec
  • Erase Data
    • Unlock
    • Cali Clear of Cali Data
      • Write 0x70, 3843
    • Reset
  • Message
    • Host -> Servo
      • ZPST, ID2 (4), ID1 (1), < set position : -32768 ~ +32767, resolution 16384 = 360 deg >
    • Host -> Servo
      • ZPGS, ID2 (4), ID1 (1), <start index : 2 byte>, <N: 2 byte>
        • 서보는 ZPVS 메시지를 보냅니다.
    • Servo -> Host
      • ZPVS, ID2 (4), ID1 (1), <start index : 2 byte>, <N: 2 byte>, <Pi : setted position>, <Vi : position sensor value>, ...
        • 서보는 최대 N개의 데이터를 보냅니다.
          • 주의: 메시지 전송 버퍼의 한계 등을 확인하여 개수를 제한해야 합니다.
Retrieved from "http://support.hitecrcd.net:7700/index.php?title=CanServo/Protocol/V1.7&oldid=1518"