Difference between revisions of "CanServo/MODE/CAN/en"
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
Actual operation depends a bit on [[CanServo/FW Type]]. | Actual operation depends a bit on [[CanServo/FW Type]]. | ||
* In FW A Type | * In FW A Type: 0,1,2 can be selected. | ||
* In FW C Type | * In FW C Type: 0,1 can be selected. Selecting 2 will act as 0 . | ||
* In FW U Type | * In FW U Type: this setting value is ignored and it operates as 2 unconditionally. | ||
** The value itself does not change. | ** The value itself does not change. | ||
** However, in FW Ver 1.1(2) [ OLD 2.1(2) ], this value is forcibly changed to 2. | ** However, in FW Ver 1.1(2) [ OLD 2.1(2) ], this value is forcibly changed to 2. | ||
Revision as of 08:29, 24 September 2021
Select which protocol to use.
- 0 - CAN 2.0A
- 1 - CAN 2.0B
- 2 - UAVCAN
Actual operation depends a bit on CanServo/FW Type.
- In FW A Type: 0,1,2 can be selected.
- In FW C Type: 0,1 can be selected. Selecting 2 will act as 0 .
- In FW U Type: this setting value is ignored and it operates as 2 unconditionally.
- The value itself does not change.
- However, in FW Ver 1.1(2) [ OLD 2.1(2) ], this value is forcibly changed to 2.
Communication settings including this setting are applied at the time of servo reset.
When changing, SAVE and Servo Reset are required.