Difference between revisions of "Interface/DPC-20/eng"

Latest revision as of 07:59, 30 May 2024

DPC-20

HW Type = PC USB-C to 3pin(PWM/TTL) and 4pin(485/CAN) interface
You can set up and test HiTEC digital servos.
Depending on the control method (PWM, 485, CAN), it can be used instead of the existing DPC-11, DPC-485, and DPC-CAN.
Since the communication content and method are different depending on the type of servo, a separate UI is used.

NOTE - DPC-485
- For cases other than the D-485 series, a separate dedicated UI may be used.
- At this time, if you use DPC-20 instead, connect it to USB, wait about 20 seconds, then open the COM port and use it like you did with DPC-485.

NOTE - When changing UI
- Please disconnect the USB cable from the DPC-20 and reconnect it.

@@ Line 8: / Line 8: @@
 |-
 | Servo Series
+| Compatible interface
 | UI
 | UI Link
-| Compatible interface
 |-
 | 5/7 series
+| DPC-11, DPC-20
 | rowspan="4" | DPC-11 PC UI (3.1.0+)
 | rowspan="4" | [[UI/DPC-11/eng | DPC-11 PC UI]]
-| DPC-11, DPC-20
 |-
 | 9 series
@@ Line 27: / Line 27: @@
 |-
 | CAN series
-| CAN AIO(All in One) UI (2023_06_14+)
+| DPC-CAN, DPC-20
+| CAN AIO (All in One) UI (2023_06_14+)
 | [[UI/CAN/AIO/eng | AIO UI]]
-| DPC-CAN, DPC-20
 |-
 |}
@@ Line 35: / Line 35: @@
 * NOTE - DPC-485
 ** For cases other than the D-485 series, a separate dedicated UI may be used.
-** At this time, if you use DPC-20 instead, connect it to USB and open the COM port after about 20 seconds to use it as before.
+** At this time, if you use DPC-20 instead, connect it to USB, wait about 20 seconds, then open the COM port and use it like you did with DPC-485.
+* NOTE - When changing UI
+** Please disconnect the USB cable from the DPC-20 and reconnect it.