Difference between revisions of "CanServo/ID2/en"

Revision as of 17:42, 23 September 2021

Register ID2 is a 4 byte value: registers 0x3E, 0x3C are called together.

According to the CanServo/MODE/CAN/en setting, specify the CAN ID or Node ID ( CanServo/ID/Node/en ) of the servo.

Refer to CanServo/Packet Accept Rule/en for the packet reception procedure in CanServo/MODE/CAN/en = CAN 2.0A, 2.0B.

Communication settings including this setting are applied at the time of servo reset. When changing, SAVE and Servo Reset are required.

Revision as of 17:40, 23 September 2021 (view source) Choiyh (talk \| contribs) ← Older edit		Revision as of 17:42, 23 September 2021 (view source) Choiyh (talk \| contribs) Newer edit →
Line 7:		Line 7:


	~~The setting values related to communication setting~~ including this setting are applied at the time of servo reset.		Communication settings including this setting are applied at the time of servo reset.
	~~Therefore, after~~ changing, SAVE and Servo Reset ~~must be performed for actual application~~.		When changing, SAVE and Servo Reset are required.