Difference between revisions of "Interface/DPC-20/eng"
Jump to navigation
Jump to search
| Line 28: | Line 28: | ||
| CAN series | | CAN series | ||
| DPC-CAN, DPC-20 | | DPC-CAN, DPC-20 | ||
| CAN AIO(All in One) UI (2023_06_14+) | | CAN AIO (All in One) UI (2023_06_14+) | ||
| [[UI/CAN/AIO/eng | AIO UI]] | | [[UI/CAN/AIO/eng | AIO UI]] | ||
|- | |- | ||
Revision as of 07:42, 30 May 2024
DPC-20
- HW Type = PC USB-C to 3pin(PWM/TTL) and 4pin(485/CAN) interface
- You can set up and test HiTEC digital servos.
- Depending on the control method (PWM, 485, CAN), it can be used instead of the existing DPC-11, DPC-485, and DPC-CAN.
- Since the communication content and method are different depending on the type of servo, a separate UI is used.
| Servo Series | Compatible interface | UI | UI Link |
| 5/7 series | DPC-11, DPC-20 | DPC-11 PC UI (3.1.0+) | DPC-11 PC UI |
| 9 series | DPC-11, DPC-20 | ||
| D series | DPC-11, DPC-20 | ||
| D-485 series | DPC-485, DPC-20 | ||
| CAN series | DPC-CAN, DPC-20 | CAN AIO (All in One) UI (2023_06_14+) | AIO UI |
- NOTE - DPC-485
- For cases other than the D-485 series, a separate dedicated UI may be used.
- At this time, if you use DPC-20 instead, connect it to USB, wait about 20 seconds, then open the COM port and use it like you did with DPC-485.