CanServo/Protocol/V1.1

CAN Protocol Ver 1.1

• This protocol needs FW Ver 1.12+

• CAN ID
  • 0x7FF : Servo -> Host
  • 0x7FE : Host -> Servo

UID

• Message : Servo -> Host
  • ZUID, <UID : 16 byte>, <ID2 : 4 byte>, <ID1 : 1 byte>, <CAN Mode : 1 byte>
  • This message is sent periodically by the servo if either servo setting ID1 or ID2 is 0.

• Message: Host -> Servo
  • ZIDS, <UID : 16 byte>, <ID2 : 4 byte>
  • ZIDS, <UID : 16 byte>, <ID2 : 4 byte>, <ID1 : 1 byte>
  • ZIDS, <UID : 16 byte>, <ID2 : 4 byte>, <ID1 : 1 byte>, <CAN Mode : 1 byte>
  • The servo with matching UID sets ID2, ID1, and CAN Mode depending on the length of the message.

• This message is delivered using the MultiPacket method below.

Write/Read Register's bits by ID or UID

• Message: Host -> Servo
  • ZGUu - Get UID
    • ID2 (4), ID1 (1)
  • ZSUU,ZXUU - Set Register by UID, ( ZXUU -> Set,Get )
    • UID (16), ADDR (1), bit 0.5, bits (0.5), Value (2)
  • ZGUU - Get Register by UID
    • UID (16), ADDR (1), bit 0.5, bits (0.5)
  • ZSID,ZXID - Set Register by ID ( ZXID -> Set,Get )
    • ID2 (4), ID1 (1), ADDR (1), bit 0.5, bits (0.5), Value (2)
  • ZGID - Get Register by ID
    • ID2 (4), ID1 (1), ADDR (1), bit 0.5, bits (0.5)
• Mesasge: Servo -> Host
  • ZRUU - return register by UID
    • UID (16), ADDR (1), bit 0.5, bits (0.5), Value (2)
  • ZRID - return register by ID
    • ID2 (4), ID1 (1), ADDR (1), bit 0.5, bits (0.5), Value (2)

File Access

• ZGFL
• ZSDF
• ZFWU

Message

• ZMSG

Long Message

CanServo/Protocol/LongMessage