CanServo/ID2/en

From HITEC_HELP

Revision as of 00:57, 24 September 2021 by Choiyh (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to navigation Jump to search

ID2 is a 4 byte value: registers 0x3E, 0x3C are called together.

0x3C - High 2 byte
0x3E - Low 2 byte

According to the CanServo/MODE/CAN/en setting, specify the CAN ID or Node ID ( CanServo/ID/Node/en ) of the servo.

Refer to CanServo/Packet Accept Rule/en for the packet reception procedure in CanServo/MODE/CAN/en = CAN 2.0A, 2.0B.

Communication settings including this setting are applied at the time of servo reset. When changing, SAVE and Servo Reset are required.

Retrieved from "http://support.hitecrcd.net:7700/index.php?title=CanServo/ID2/en&oldid=413"