CanServo/Protocol/UAVCAN/en

This is the protocol used when CanServo/MODE/CAN/en = UAVCAN.

• If CanServo/MODE/CAN/en = 2.0A, 2.0B, refer to CanServo/Protocol/Control/en.

Because the UAVCAN v0 protocol is very extensive, it only supports the following messages essential for servo control.

• Node Status
• GetNodeInfo
• Actuator.ArrayCommand
• Actuator.Status

When changing or reading the register value of the servo, it is used in a way that expands the shape of Actuator.ArrayCommand without damaging it.

Return Message is used by modifying the data part of Actuator.Status. This part does not conform to the UAVCAN standard.

Write Register ( arraycommand )

• 0003F20xx AA BB LL HH cc
  • xx = Host Node
  • AA = Servo's Actuator ID (ID1) = 0 ~ 127
  • BB = Address of Register
  • LL = Low Byte of Write Data
  • HH = High Byte of Write Data
  • cc = tail byte of dronecan
  • ex) 0003F207 02 6A 01 00 Cd